What to do if the Mijia Front Load Washer Dryer Pro 9kg is slow to fill with water?

If the Mijia Front Load Washer Dryer Pro 9kg is slow to fill with water, please refer to the following methods to troubleshoot:
  1. Check the water inlet filter for clogs. A clogged filter can cause water flow obstruction. Please clean the filter.
(1). Turn off the water tap and unplug the power cord. Loosen and remove the water inlet hose from the back of the washer dryer. Cover the port with a cloth to prevent water from spraying out.
(2). Pull out the filter cover from the water inlet valve hole with nipper pliers and clean it thoroughly.
(3). Use a brush to clean the inside and the outside of the threaded connector.
(4). Reinstall the water inlet valve filter cover. Turn on the water tap and make sure there is no water leakage at the connection.
  1. Check the water inlet hose for kinks that could cause water flow obstruction.
  2. Check that the water pressure is between 0.05 and 0.8 MPa. Low water pressure can cause water flow obstruction. Alternatively, avoid peak usage hours. If this problem persists, we recommend purchasing a booster pump, but do not adjust the water pressure above 0.8 MPa.

Does it help?

Yes
No