Why is there a water dripping phenomenon when the Xiaomi Truclean W20 Wet Dry Vacuum is stopped and lifted?
1. When the Xiaomi Truclean W20 Wet Dry Vacuum is shut down, it leaks water. To protect the motor, there will be a corresponding delay in closing the motor. Therefore, the device operation does not immediately end during the shutdown, and it is still in a short water absorption and drainage cycle. At this time, the device is suspended from the ground, and can only discharge water but cannot absorb water, so there will be some dripping phenomenon, which does not affect normal use;
2. During the use of the main unit, the water in the water tank is in dynamic flow. When the main unit is completely shut down and left standing, some of the dynamic water flowing in the water tank pipeline will slowly drip out, which does not affect normal use.
For your reference, here are the steps to use the vacuum properly:
1. You can set the body upright to pause cleaning or press the power button to shut down. To prevent residual dirty water, the vacuum will continue to run for a few seconds before shutting down. After the vacuum is completely stopped, it will be placed back on the cleaning base;
2. In the upright pause or shutdown state, pull the handle backward and use the scroll wheel to push the host to the cleaning base for storage, charging, and self-cleaning;
3. After use, please correctly place the cleaning base back to prevent the floor scrubber from tipping over due to improper placement. Do not lift the entire floor scrubber vertically (as shown in the figure below) to prevent sewage from flowing out.
2. During the use of the main unit, the water in the water tank is in dynamic flow. When the main unit is completely shut down and left standing, some of the dynamic water flowing in the water tank pipeline will slowly drip out, which does not affect normal use.
For your reference, here are the steps to use the vacuum properly:
1. You can set the body upright to pause cleaning or press the power button to shut down. To prevent residual dirty water, the vacuum will continue to run for a few seconds before shutting down. After the vacuum is completely stopped, it will be placed back on the cleaning base;
2. In the upright pause or shutdown state, pull the handle backward and use the scroll wheel to push the host to the cleaning base for storage, charging, and self-cleaning;
3. After use, please correctly place the cleaning base back to prevent the floor scrubber from tipping over due to improper placement. Do not lift the entire floor scrubber vertically (as shown in the figure below) to prevent sewage from flowing out.
Does it help?
Yes
No