MIJIA sensing night light FAQ

A: It cannot be operated and set by phone.

 

A: MIJIA sensing night light is of cylinder pie structure, with its diameter of 84mm, height of 36mm and weight of 73±2g.

 

A: Yes, there are three pieces of double A, R6 batteries.

 

A: No.

 

A: Dose it have a high power? Only 0.25 w.

 

A: 0.25mw.

 

A: The color temperature cannot be regulated, with a fixed value of 2700K.

 

A: It has two gears, with low gear of 0.7Lumen and high gear of 3.8Lumen.

 

A: Service life: about 25,000 h.

 

A: The ON/OFF function of sensing night light can be achieved through sensing physical activity. Under dark light, if it sensed physical activity, it will automatically light switch on; while, under bright light, it will automatically go to sleep. Under bright light, if the light is power on or switches on and it can sense physical activity continuously, it is normal that the light keeps on.

 

A: The light obtains the power from three pieces of double A, R6 alkaline batteries, with its working voltage of 4.5V.

 

A: It can sense physical activity within 5-7m right ahead and within 2-3m of its side at a level angle of 120°, and its sensing ability is subject to environment temperature, human body and movement speed.

 

A: After switching on, the light will last for 14-16s. If the light can sense physical activity all the time (whether the ambient light is dark or bright), the light will keep its working state until it cannot sense any physical activity, and then the light will switch off after delay.

 

A: 1. Do not install the light near heat source, such as locations with rapid temperature change of outlet of air conditioner, outlet of heating, humidifier, and do not install the light at places with strong light. 2. The height of 0.4m-1m is recommended, and the light shall be sticked on the wall vertically (cannot be sticked on the roof or ceiling). The recommended places include bedroom, drawer, closet, vestibule and corridor (the light can be placed on the use position firstly, and then install it with adhesive tape after confirmation.) 3. Keep the logo vertically upward while installing it, without any leaning and slanting.

 

A: When the ambient temperature is above 25 ℃, the sensing effect will be reduced.

1. Correctly install three pieces of double A, R6 batteries as per the mark; mix use of new and old batteries is not allowed, which will affect the service life of battery. Generally, the battery can be used for 5-6 months, and yet the service life is subject to its type and LED light frequency.

2. After normal use for a period, if the luminance of the night light is low or it cannot work normally, it means that the batteries run out, and then replace the batteries with new ones. Please recycle waste batteries to avoid environmental pollution.

3. Because of strong adhesiveness of the fixing glue, when replacing batteries, take off the light body through rotating it counterclockwise, and do not pull the light directly, in order to avoid damaging the light.

4. Do not cover the surface of the lens on the product with other materials, in order not to affect the sensing effect.

5. Please clean the surface of the lens with soft cotton cloth, avoiding using any corrosive agent.

6. Because the material of the lens is soft, do not scratch, impact or apply load on the lens. The above activities can cause deformation and damages to the product, which can lead to poor actions of the product or other function faults.

 

A: 1. Check whether the batteries are installed in the correct direction, and whether the contact is in good condition. 2. Check whether the batteries have normal battery capacity.