How to clean the brush, side brush and universal wheel of the Xiaomi Robot Vacuum S20+?
The steps of cleaning the brush are shown below:
1. Turn the bottom of the robot vacuum upwards, press the main brush release button to remove the main brush cover;
2. Take out the main brush upwards, unplug the bearings at both ends, and clean the main brush shaft;
3. Use scissors to cut off the hair wrapped around the main brush and clean up the debris;
4. Reinstall the main brush bearing, main brush and main brush cover and lock them in place.
Note:
When the hair is too tightly wrapped, do not pull it hard to avoid damaging the main brush.
The way of cleaning the side brush is shown below:
Turn over the robot vacuum, pull out the side brush upwards and clean it. Then install the side brush back into the robot vacuum.
The ways of cleaning the universal wheel are shown below:
1. Turn over the robot vacuum and pull out the universal wheel upwards;
2. Clean the hair and dirt on the wheel body and the axle;
3. Reinstall the universal wheel and press it tightly.
Note:
1. If necessary, you can use a small screwdriver or other tools to pry out the universal wheel for cleaning. Do not use too much force;
2. You can rinse it with tap water and install it after drying.
1. Turn the bottom of the robot vacuum upwards, press the main brush release button to remove the main brush cover;
2. Take out the main brush upwards, unplug the bearings at both ends, and clean the main brush shaft;
3. Use scissors to cut off the hair wrapped around the main brush and clean up the debris;
4. Reinstall the main brush bearing, main brush and main brush cover and lock them in place.
Note:
When the hair is too tightly wrapped, do not pull it hard to avoid damaging the main brush.
The way of cleaning the side brush is shown below:
Turn over the robot vacuum, pull out the side brush upwards and clean it. Then install the side brush back into the robot vacuum.
The ways of cleaning the universal wheel are shown below:
1. Turn over the robot vacuum and pull out the universal wheel upwards;
2. Clean the hair and dirt on the wheel body and the axle;
3. Reinstall the universal wheel and press it tightly.
Note:
1. If necessary, you can use a small screwdriver or other tools to pry out the universal wheel for cleaning. Do not use too much force;
2. You can rinse it with tap water and install it after drying.
Does it help?
Yes
No