How to connect the Water Inlet Hose of the Mijia Front Load Washer Dryer Pro 9kg?

Question

Accepted Answer

To connect the Water Inlet Hose of the Mijia Front Load Washer Dryer Pro 9kg, please refer to the following steps:
1. Attach the provided water inlet hose directly to a 6-point (3/4 inch) external thread faucet, ensuring a tight seal.
2. Connect the other end of the water inlet hose to the washer dryer's water inlet valve (located at the back), and tighten it clockwise to secure.
3. Turn on the faucet and check all connections for leaks. If any leaks are found, tighten the affected fitting by following the previous steps. If the faucet itself is leaking, replace it promptly.

Note:
1. The washer dryer comes with a 1.5 m water inlet hose. If a longer hose is needed, you can request one from the installation personnel.
2. There is no clear regulation on the maximum extension of the Water Inlet Hose of the washer dryer. It can be used as long as it meets the water pressure requirement of 0.05 MPa - 0.8 MPa.