What to do if there's water leakage of Water Inlet Hose of the Mijia Front Load Washer Dryer 10.5kg?

To solve water leakage of Water Inlet Hose of the Mijia Front Load Washer Dryer 10.5kg, please refer to the following steps to troubleshoot:
1. Check whether the position where the faucet is connected to the Water Inlet Hose is loose. Please reconnect it and use a reliable faucet.
To connect the Water Inlet Hose, please refer to the following steps:
(1). Based on the installation environment, determine whether it is necessary to replace the quick connector (A) with 6-point connector (B);
(2). Clean the filter (A) regularly according to its contamination level;
(3). Use a screwdriver to loosen 4 screws on the quick connector;
(4). Hold the quick connector and rotate part (C) in the direction of the arrow to loosen it by approximately 5 mm;
(5). Insert the quick connector upward into the water outlet of the tap and tighten the screws at the same time. Rotate part (C) in the direction as illustrated to secure the connection;

2. If the Water Inlet Hose joint is leaking, please contact the after-sales service center to provide a new Water Inlet Hose.