How to use the omni station of the Xiaomi Robot Vacuum X20 Pro?
To use the omni station, please refer to the following steps:
1. To achieve a better experience, please place the omni station against the wall on a hard horizontal ground (such as a floor, tile, etc.) near a power outlet and in an area with a good Wi-Fi signal;
2. Make sure there is space of more than 0.82 meters in height, more than 1.93 meters in length, and more than 0.44 meters in width. Plug the connector of the cord set into the power port of the omni station until the indicator stays white;
3. Install the washboard base extender to the omni station along the direction as illustrated. Make sure the washboard base extender is flush with the bottom of the omni station, and the bottom surface is even (If there is any installation jamming during assembly, please make sure to press it in place);
4. Before use, press and hold the power button on the robot vacuum for 3 seconds to turn it on. Once the robot vacuum is on, place it onto the omni station, and make sure the charging contacts on the robot vacuum and the station are fully aligned. The robot vacuum connects to the omni station successfully when you hear a voice prompt to start charging;
5. For the first use, it is recommended to fully charge the robot vacuum. The indicator on the omni station will light on (the indicator will be turned off when it is in DND mode. You can cover the indicator with a sticker). If the robot vacuum cannot be turned on due to the low battery level, manually place the robot vacuum onto the omni station to charge it for a while. When the robot vacuum is being charged, it will automatically turn on and cannot be turned off.
1. To achieve a better experience, please place the omni station against the wall on a hard horizontal ground (such as a floor, tile, etc.) near a power outlet and in an area with a good Wi-Fi signal;
2. Make sure there is space of more than 0.82 meters in height, more than 1.93 meters in length, and more than 0.44 meters in width. Plug the connector of the cord set into the power port of the omni station until the indicator stays white;
3. Install the washboard base extender to the omni station along the direction as illustrated. Make sure the washboard base extender is flush with the bottom of the omni station, and the bottom surface is even (If there is any installation jamming during assembly, please make sure to press it in place);
4. Before use, press and hold the power button on the robot vacuum for 3 seconds to turn it on. Once the robot vacuum is on, place it onto the omni station, and make sure the charging contacts on the robot vacuum and the station are fully aligned. The robot vacuum connects to the omni station successfully when you hear a voice prompt to start charging;
5. For the first use, it is recommended to fully charge the robot vacuum. The indicator on the omni station will light on (the indicator will be turned off when it is in DND mode. You can cover the indicator with a sticker). If the robot vacuum cannot be turned on due to the low battery level, manually place the robot vacuum onto the omni station to charge it for a while. When the robot vacuum is being charged, it will automatically turn on and cannot be turned off.
Does it help?
Yes
No