Mi 5-Blade Electric Shaver FAQ

1.Q: What features does Mi 5-Blade Electric Shaver have?

A:

 

2. Q: Product introduction of Mi 5-Blade Electric Shaver

A:

 

3.Q: Indicator introduction

A:

Lock indicator:

1. Long press the power button for about 3 seconds, the shaver lock machine, lock indicator light will bright in white for 3 seconds and then off.

2. In the lock state, short press the power button, and the lock indicator blinks for three times, indicating that it is in the lock state.

3. In the lock state, long press the power button for about 3 seconds, and the shaver will be unlocked and enter the working state.

 

4.Q: Use introduction

A: Shaving

1. For the first use, long press the power button for 3 seconds to unlock the machine and enter the working state. For subsequent use, short press the power button to switch on and off normally.

2. When shaving, it is recommended not to press the blade head too hard, otherwise the sharp inner blade may damage the skin. It is recommended that the outer blade net should be vertically and lightly applied to the skin, and move slowly against the growth direction of the beard. At this time, the skin should be kept tight to obtain a better shaving effect.

Note:

1. When shaving the chin, neck and other soft and difficult to shave, it is recommended to tighten the skin and shave up and down repeatedly.

2. If there are acne, pimples, cuts and other skin problems on the face, please use with caution to avoid scratching the skin.

1. When the battery is remaining 10%-20%, the battery indicator on the machine brights in red.

2. When the battery is lower than 10%, the battery indicator blinks red for 3 times and then powers off.

3. Plug the Charging cable of Type-C into the charging port and connect to the power supply to charge. When charging, the battery indicator light blinks. When the battery is fully charged, the battery indicator brights in white.

1. To keep the shaver efficiently, clean the shaver immediately after shaving.

2. When cleaning the shaver, the shaver should be turned off and not charged.

3. Pull out the blade head vertically upward, use a brush to clean the dirt inside the blade head component, or put it under the faucet for washing.

4. Use a brush to clean the stubble on the machine or put it under the faucet for washing.

5. Keep the blade head assembly dry, and then reinstall the body, cover the protective cover, and properly keep.

6. After daily use, please keep the blade dry. Avoid long-term storage in sunlight and other heat sources. Please disconnect the charging cable when storing.

Note:

1. The blade head adopts magnetic suction design, and The installation is not divided into the front and back sides;

2. Do not use a cleaning brush to clean the outer blade net, so as not to cause damage to the outer blade net;

3. After rinsing the blade head assembly, if the residual moisture inside is not cleaned in time, peculiar smell may appear. It is suggested that after rinsing, shake off the moisture and install the bade head after it is completely dry.

1. When replacing the blade head component, ensure that the shaver is in the locked state to avoid powering on.

2. Remove the old blade head vertically upward, and install the new blade head vertically downward on the machine.

Note: The life of the blade head component depends on the frequency of use and the length of use. It is recommended that the blade head component be replaced annually.

 

5.Q: What material of Mi 5-Blade Electric Shaver’s machine body and five-blade head？

A: 1.The machine body: polymer fiber material, has the ability to resist pressure and fall.

2.Five-blade head: the blade head support is made of polymer plastic, and the blade net is made of electrofor