Explanation：
1, install electrostatic paste
Install the electrostatic tape on the front glass in the recommended installation area in the following picture. Please wipe the glass clean with dust removal cloth before installation.
2. Connect the Dashcam and the bracket
Insert the bracket down into the bracket slot at the top of the Dashcam and push it to the left. The connection will be completed when hear the "click" sound.
3. Paste Dashcam
As shown in the figure below, remove the centrifugal paper on the base of the bracket and paste the bracket into the middle of the electrostatic paste.
4. Lay out wires to get electricity
As shown in the following figure, line the charging line along the top of the front shield glass, pillar A and the passenger compartment to the cigarette lighter mouth. After connecting the car charging head, plug it into the cigarette lighter mouth to take power.The position of cigarette lighter mouth may be different in different vehicles. The figure is for reference only. You can use the pry bar in the packing box to bury the car charging line into the A-pillar rubber strip.
